Installation guide

INSTALLATION GUIDE
22
5.3 Controller Installation, Meto-Logic, continued
5. Attach the AC power cord supplied from the AC output receptacle of the power strip (Figure 5-17) to
the input AC receptacle of the Meto-Logic controller.
6. Attach the AC power cord supplied from the AC input receptacle of the power strip to the Switched AC
receptacle of the Printer as shown in Figure 5-17.
7. Attach one end of the ground strap to the rear of the controller frame and the other end to an available
printer chassis screw as shown in Figure 5-16. Leave enough ground strap slack to allow the
controller to be completely removed from lower cabinet for service.
8. Attach the appropriate data cables from the connector panel harness to the appropriate controller
ports.
Printer Chassis
AC Input
115/230V Power
Setting
RS-232 (Com1 Port)
Parallel
Port
Monitor Port
USB Port (4)
Ethernet Port
TDU Port
PIFCII Connector
Printer Power Cable
Figure 5-16
Meto Logic-Controller
Ground Strap