Installation guide

INSTALLATION GUIDE
12
4.5 Installation of the Suction Brake Unit
1. Remove the Suction Brake, three mounting screws and two connector cover mounting screws
from accessories Box 2.
2. Mount the Suction Brake Unit onto the four mounting holes as shown in Figure 4-1.
3. Fasten the Suction Brake (Figure 4-2) using the three mounting screws supplied.
4. Connect the 3P connector of the Form End Sensor to the Suction Brake Unit.
5. Mount the 3P connector cover with the two remaining screws supplied.
Figure 4-2
Figure 4-1
3P Connector