Installation guide

INSTALLATION GUIDE
1
CHAPTER 1. Preliminary Instructions
1.1 Operating Location Requirements
1. Refer to Appendix A, “LP 100R Printer Operation Location Requirements” and perform the steps
provided to determine if all requirements have been met.
2. If the operating location requirements have been met, proceed to paragraph 2.1.
1.2 Unboxing and Unpacking Instructions
1. If the printer has not been unboxed, refer to paragraph 2.2, "Removal of Packing Material and
Accessories Boxes” and perform the provided steps.
2. If the printer controller has already been unboxed, proceed to paragraph 5.3, “Controller Installation,
Meto-Logic.”
In the event that the printer was already located in its operating location when unboxed, SKIP
paragraph 2.2 “Removal of Packing Material and Accessories Boxes” and proceed as
instructed.
1.3 Before Moving the Printer to the Operating Location
1. Before moving the printer to its operating location, measure the width of the door opening. Proceed to
paragraph 3.1.
1.4 Door Opening Minimum Width Requirements
When moving an “out of box” LP 100R printer through a door opening, ensure that door openings are
no smaller than the required minimum width of 35” (889 mm).
1. Measure all door openings through which the printer must pass to reach its operating location.
2. To move a printer that has been existing in an operating location, remove the Suction Brake Unit from
the printer. Refer to paragraph 4.5, "Installation of the Suction Brake Unit."