Instruction manual

Section 3: Operation and Configuration
Page 3-34 GY412 Operator Manual
3.3 LCD MESSAGE DETAILS (cont’d)
Display User Mode - Adjustment of base point for printing on the upper surface
Onscreen
message
This coordinates the base point for printing on the
upper surface.
Use the up and down arrow buttons to change
setting value and press ENTER.
Use the left and right arrow buttons to move the
cursor, and to select an input item.
V is the vertical print position and H is the hori-
zontal print position.
You can set this by 1 dot, and the default setting
is V:+0000 H:+0000, regardless of print density.
Setting range:
V: ±0 to 1200, H: ±0 to 1200.
Operation
button
Button Description
↓, ↑
Enters setting value.
Move the cursor to + and - for its switch over.
→, ← Moves the cursor.
ENTER Saves the setting, and goes to the PITCH OFF-
SET LOWER HEAD screen.
CANCEL Goes to the PRINT DARKNESS LOWER HEAD
screen without saving the setting.
FUNCTION Goes to the ONLINE MODE screen, without sav-
ing the setting.
PITCH OFFSET
UPPER HEAD
V:+0000 H:+0000