Instruction manual

Section 2: Installation
Page 2-8 GY412 Operator Manual
2.4 CONNECTIONS, CONT’D
2.4.5 SD Card
The SD card is used for uploading and downloading the data (graphics, extended character) and the printer
firmware saved in the printer. The following are the folder and file names to be stored (or viewed) when
uploading (or downloading).
To insert, seat, and remove the SD or Memory Card
1. To insert the SD card, hold it as shown in the figure below.
2. To seat the card in the slot, press it in until it makes a slight clicking sound and it is almost completely
inside the printer. When seated and ready to operate, it protrudes a very small amount, approximately
0.125 inch (3.18 mm).
3. To remove the card from the printer, it is best to switch off the printer. Then, with your finger, press the card
edge a slight amount to release the card from the slot. The slot will immediately release the card.