Instruction manual

Section 8: Appendix
GY412 Operator Manual Page 8-31
8.10 PRINT OPERATION SEQUENCE (cont’d)
8.10.7 Print-Cut Mode (Head check disabled)
Notes:
• The above is the base position when the I-mark sensor is selected.
• Send the print data for two labels.
ཱ཰
ིཱ཰
཰
ཱ཰
ིཱ཰
ཱིིཱ཰
ཱིིཱ
ཱིིཱ
Upper head
Pitch sensor
Standby
Lower head
The upper head is up.
The lower head is down.
Backfeed motion starts.
Stop printing if the end of the first
label comes to cut position.
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Backfeed to pitch
sensor position
The upper head is down.
The lower head is up.
Start feeding the label and
printing from the lower surface
of the first label.
The lower surface of the first
label is printed. When the
second label is fed while
printing the upper surface of
the first label, the print on the
lower surface of the second
label will start.
Cut position
Up
Down
Cut the first label.
཰
Up
Down
Start printing the second label.
(1) Motion
Label feed direction