Instruction manual

Section 8: Appendix
GY412 Operator Manual Page 8-27
8.10 PRINT OPERATION SEQUENCE (cont’d)
8.10.5 Cutter Mode (Head check disabled)
Notes:
• The above is the base position when the I-mark sensor is selected.
ཱ཰
ིཱ཰
཰
ཱ཰
ིཱ཰
ཱིིཱ཰
ིཱ
ཱིིཱ
Upper head
Pitch sensor
Standby
Lower head
The upper head is up.
The lower head is down.
Backfeed motion starts.
After finishing double sided print of
the first label, the label is fed to cut
position.
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Backfeed to pitch
sensor position
The upper head is down.
The lower head is up.
Start feeding the label and
printing from the lower surface
of the first label.
The lower surface of the first
label is printed. When the
second label is fed while
printing the upper surface of
the first label, the print on the
lower surface of the second
label will not start.
When the next data is ready;
The upper head is up.
The lower head is down.
Backfeed motion starts.
Position adjustment at the top
of the second label.
Up
Down
Cut position
Up
Down
Label cut
཰
(1) Motion
Label feed direction