Instruction manual

Section 8: Appendix

GY412 Operator Manual Page 8-11

8.4 AUTO LABEL FEED

When the printer runs out of label completely, the thermal head and the roller will be lifted up for loading the

label from the rear side of the printer.

After loading the label, close the platen and adjust the label position.

Depending on the sensor type to be used, the top of label or I-mark will be detected and then, the label will be

fed to the standby position. Label feed speed for auto paper feed is fixed at 3 inch/sec.

Note:

• The above is the base position when the I-mark sensor is selected.

Upper head

Pitch sensor

No label

Lower head

Load the label, close the

platen and adjust the label

position

Down

཰

Down

཰

Feed the label backward to the

pitch sensor position and detect

the top of label or I-mark

Feed the label to the standby

position and complete the auto

label