Instruction manual

Section 8: Appendix
GY412 Operator Manual Page 8-5
8.1 CUTTER AND PRINTER MOTION (cont’d)
8.1.3 Print operation sequence
The following print modes are selectable through [ADVANCED MODE] on the operation panel.
Refer to Section 3, Operation and Configuration, for more details.
8.1.4 Base Reference Position
The print reference position differs by the print mode and the label pitch sensor.
8.1.4.1 Continuous Mode
The base position for printing in continuous mode is shown below.
For the I-mark sensor, the top of label is the base position for printing.
For the GAP sensor, the top of label is the base position for printing.
PRINTER
TYPE
TEAR OFF
CONTINUOUS
CUTTER
PRINT-CUT
I-mark
Base position for
printing
GAP
Base position for
printing
Label feed direction