Instruction manual

Section 6: Basic Specifications
Page 6-12 GY412 Operator Manual
6.1 PRINTER BASIC SPECIFICATIONS (CONT’D)
ITEM LEVEL ADJUSTMENT
CE adjustment
(1) I-mark sensor level adjustment
(2) GAP sensor level adjustment
Factory adjustment (1) Factory print position adjustment (through LCD screen)
User adjustment
(1) Print darkness adjustment (through LCD screen)
(2) Print position adjustment (through LCD screen)
(3) Cutter and tear-off stop position adjustment (through LCD screen)
ITEM DESCRIPTION
Paper length detection sensor
(1) I-mark sensor (Reflective type)
(2) GAP sensor (Transmissive type)
Various sensors
(1) Cover open sensor
(2) Cutter sensor
(3) Head up/down sensor
Other settings
Print speed, print darkness, and various offset settings can be configured through
the computer using the printer setting tool or can be configured through the printer
LCD screen.
Buzzer
Built-in buzzer
* Buzzer can be ON/OFF by the command specification
* Volume control function available (VR setting)
Operability
(1) Easy label loading (Label feed from the rear upper)
(2) Automatic label feed function
(3) Power switch located on the front side
(4) Easy operation. Vertical motion structure for opening/closing thermal head.
(5) Easy cleaning of head and platen roller
Toughness
Unpackaged product drop impact not acceptable
Vibration and drop test of packaged product equivalent to ISTA-2A
Durability
Platen: 50km guaranteed
Thermal head: 30km guaranteed
Belt: 50km guaranteed
Motor: 20,000 hours guaranteed
Standard accessories
(1) Quick Guide booklet
(2) Thermal head cleaning sheet
(3) Power cable
(4) Warranty
(5) Accessory CD-ROM