Instruction manual

Section 6: Basic Specifications
Page 6-6 GY412 Operator Manual
6.1 PRINTER BASIC SPECIFICATIONS (cont’d)
MEDIA (Be sure to use media manufactured or certified by SATO)
Paper Setting Position Center position
Paper Thickness
Label: 100 to 320 μm
Label: 0.003 to 0.012 in. (0.1 to 0.32 mm)
Size
Continu-
ous mode
Tear-off
mode
Cutter
mode
Label
cutting
during
print
operation
Label
Label
Label
Label
Pitch: 1.18 to 11.81 in.(Backing liner 1.29 to 11.9 in.)
Width: 1.96 to 5.15 in. (Backing liner 2.04 to 5.19 in.)
Pitch: 30 to 300 mm (Backing liner 33 to 303 mm)
Width: 49 to 129 mm (Backing liner 52 to 132 mm)
Pitch: 1.18 to 11.81" (Backing liner 1.29 to 11.9")
Width: 1.96 to 5.15 in. (Backing liner 2.04 to 5.19 in.)
Pitch: 30 to 300 mm (Backing liner 33 to 303 mm)
Width: 49 to 129 mm (Backing liner 52 to 132 mm)
Pitch: 1.18 to 11.81" (Backing liner 1.29 to 11.9")
Width: 1.96 to 5.15 in. (Backing liner 2.04 to 5.19 in.)
Pitch: 30 to 300 mm (Backing liner 33 to 303 mm)
Width: 49 to 129 mm (Backing liner 52 to 132 mm)
Pitch: 1.18 to 11.81" (Backing liner 1.29 to 11.9")
Width: 1.96 to 5.15 in. (Backing liner 2.04 to 5.19 in.)
Pitch: 30 to 300 mm (Backing liner 33 to 303 mm)
Width: 49 to 129 mm (Backing liner 52 to 132 mm)
*Note: The size may be limited by use conditions.
Type Direct Thermal fanfold
LABEL ISSUING MODES
Standard: Continuous mode, Tear -off mode, Cutter mode, and Label Cutting During
Print Operation mode
COMMAND
SBPL Version 4.6 or higher
SEMBL Version 1.0 or higher