Instruction manual

Section 3: Operation and Configuration
Page 3-78 GY412 Operator Manual
3.3 LCD MESSAGE DETAILS (cont’d)
Display Test Print Mode - Test print size setting
Onscreen
message
Selecting test print size.
Use ← and → to move the cursor and press
ENTER.
"SMALL": Performs test print in 4cm wide.
"LARGE": Performs test print in 10cm wide.
The initial cursor position is “LARGE”.
Operation
button
Button Description
→, ← Moves the cursor.
ENTER Selects test print size and goes to the [PITCH
POSITION UPPER] screen.
CANCEL Goes to the TEST PRINT MODE screen.
FUNCTION Goes to the TEST PRINT MODE screen.
Display Test Print Mode - Adjustment of print position on the upper surface
Onscreen
message
Adjusting the print position on the upper surface.
Use ↑ and ↓ keys to change setting value and
press ENTER to start test print.
The setting value can be adjusted by ±0.25mm
regardless of print density.
The setting range is ±3.75mm and the default set-
ting is “+0.00”mm.
Operation
button
Button Description
↓, ↑ Enters setting value by ±0.25mm.
←, → Toggles the screens.
ENTER Starts test print.
CANCEL Goes to the [TEST PRINT SIZE] screen.
FUNCTION Goes to the [TEST PRINT MODE] screen.
LARGE
TEST PRINT SIZE
SMALL
PITCH POSITION UPPER
+0.00
ENTER -> PRINT