Specifications

Section 3: Configuration and Operation
GL Series Operator’s Manual Page 3-5
3.4 USER MODE (CONT’D)
3.4.1 Setting the Pitch Offset
This setting adjusts where printing begins vertically, relative to the
bottom edge (nearest the print head) of each label. The maximum
value allowed is 3.75 mm.
Adjusting the OFFSET potentiometer adjusts the tear-off stop
position for use with a cutter, peeler.
Finally, adjusting the Print Darkness potentiometer adjusts the
print darkness.
When all the settings are satisfactory, press the ENTER button to
proceed to set other parameters in the User Mode.
3.4.2 Setting Print Speed
This setting can be used to achieve a high print speed that does not
compromise print quality. Press the ^ and v cursor keys to
change the setting. Press the ENTER button to confirm a setting
and proceed to the next screen.
If quality printing cannot be obtained due to the quality of the paper
or the printing contents, lower the speed accordingly.
Print head
direction of label motion
ref point 0,0
Print offset
Print Speed
4 ips*