Specifications

Section 2: Installation
GL Series Operator’s Manual Page 2-19
2.5 TURNING THE PRINTER ON/OFF
1. After removing the cable cover at the rear of the printer, you
can proceed to install the interface and power cables as
shown.
2. To limit movement of the cables, you can optionally channel
the cables through the cable hook area at the base of the
printer.
3. Insert the power cable first to the printer, then connect the
other end to the power outlet. If necessary, use an adapter to
match the prongs on the power cable to the sockets in the
AC outlet.
Caution
• Always use a grounded power cable to protect against electrical leakage and
electrical shocks.
4. To turn the printer ON, press the power switch to the “I” side.
When the printer is successfully turned on, the LCD screen
will be activated, and a series of diagnostic messages and
startup information will be displayed.
Caution
• To prevent electric shocks, make sure your hands are dry when you operate the
power switch, or when you pull out or insert power cables and switches.
5. If the printer does not respond, refer to the Troubleshooting section of this manual.
6. Before turning the printer off, perform the following steps:
Take the printer offline by pressing the Line button.
• Press the Feed button to eject any label at the front of the printer.
• Lightly pull the paper diagonally downward to tear off the label.
7. To turn the printer off, press the power switch to the “O” side.