Specifications

7-35Functions for Configuration
SATO Users Manual
Setting the Print Server IP address. The IP
address must be 4 numbers, each between 0-
255 (eg. 192.168.100.10).
0.0.0.0
Setting the print server subnet mask. The subnet
mask must be 4 numbers, each between 0-255
(eg. 255.255.255.0). However, entering 0.0.0.0
would not be valid, and the subnet mask
corresponding to the IP address would be used
automatically.
0.0.0.0
Setting the default gateway address. The default
gateway address must be 4 numbers, each
between 0-255 (eg. 192.168.100.240). If you use
a gateway, the gateway must be in the same
segment as the print server. However, entering
0.0.0.0 would not be valid.
0.0.0.0
You can select to use a banner page when
printing with LPR and FTP. (A banner page is
print cover page with print job explanations.)
DISABLE
Setting the DNS server (primary) address. When
/SMTP server name is configured directly at IP
address, the DNS server's setting is not
necessary.
0.0.0.0
Setting the DNS server (secondary) address.
When SMTP server name is configured directly
at IP address, the DNS server's setting is not
necessary. The values must be 4 numbers, each
between 0-255 (eg. 192.168.100.10).
0.0.0.0
Enable/Disable SMTP protocol operations. If
"Disable" is selected, e-mail "send" function is
not available.
DISABLE
Setting SMTP server host name. Entering
domain name or IP address as host name. If a
domain name is used, it is necessary to
configure the DNS server.
-
Setting the sender address (From Address).
Usually the mail address of the network
administrator is set.
-
Subnet mask
Gateway address
lpr/ftp banner
DNS Server (Pri.)
DNS Server (Sec.)
Reply-To address
DNS
DNS Server (Pri.)
DNS Server (Sec.)
IP addressIP address
Subnet mask
Gateway address
lpr/ftp banner
DNS Config
TCP/IP
Web browser
Item
Explanation
TELNET
Factory
Default
SMTP
SMTP protocol
SMTP server name