Specifications

7-10Functions for Configuration
SATO Users Manual
TCP/IP Configuration
Tab Explanation
Factory
Default
Enable/Disable TCP/IP protocol operations. This
has influence on the configuration of Setup Tools,
LPR, FTP, TELNET, SNMP, HTTP and other
protocols over TCP/IP.
ENABLE
Enable/Disable DHCP/BOOTP protocol operations.
DHCP/BOOTP is a protocol, via which IP address
gets assigned by the BOOTP server or DHCP
server. If you use DHCP/BOOTP server, the
DHCP/BOOTP server must be in the same
segment as the print server. This print server
detects DHCP and BOOTP automatically. If more
than 1 address get returned, the IP address which
is returned first will be used.
ENABLE
Enable/Disable RARP protocol operations. RARP
is a protocol, via which IP address gets assigned
by the RARP server. If you use RARP server, the
RARP server must be in the same segment as the
print server.
ENABLE
Setting the Print Server IP address. The IP address
must be 4 numbers, each between 0-255 (eg.
192.168.100.10).
0.0.0.0
Setting the print server subnet mask. The subnet
mask must be 4 numbers, each between 0-255
(eg. 255.255.255.0). However, entering 0.0.0.0
would not be valid, and the subnet mask
corresponding to the IP address would be used
automatically.
0.0.0.0
Item
Use TCP/IP Protocol
Use DHCP/BOOTP
Use RARP
Subnet Mask
TCP/IP
IP Address