Specifications

26 DR300
2. Configuration Operation Manual
Horizontal Offset
Set the Horizontal Offset value to establish a new base reference
point. To change the setting perform the following steps:
STEP PROCEDURE
1. Use the LINE key to switch between the positive (+) or the nega-
tive (-) selection. A positive selection moves the horizontal base
reference point to the right side of the label in print direction, while
a negative selection moves the horizontal base reference point to
the left side of the label in print direction.
2. Once the correct setting is underlined,
press the FEED key to accept the set-
ting and advance to the adjustment.
3. Use the LINE key to step the counter to the desired position. The
display will increment one step for each time the LINE keyispres-
sed. If the LINE key is held down for more then two seconds, it will
automatically go into the fast scroll mode (max. 400).
4. Once the setting is correct, press the FEED key to accept the set-
ting and advance to the Print Darkness Setting.
5. You may wish to check your settings by printing a test label after
you have completed the adjustments to ensure that they are cor-
rect.
H:OFFSET
H:±0000
H:OFFSET
H:±000