Specifications

Operation Manual 2. Configuration
DR300 25
Print Speed Adjustment
There are three SPEED settings on the DR300. Each setting is
listed on the bottom line of the display. The current setting is indi-
cated by an underline under one of the speed settings.
To change the setting perform the following steps:
Vertical Offset
Set the Vertical Offset value to establish a new base reference
point. To change the setting perform the following steps:
1 = 75 mm/s
2 = 100 mm/s
3 = 125 mm/s
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to the desired setting.
2. Once the correct setting is underlined, press the FEED key to accept
the setting and advance to the next adjustment.
STEP PROCEDURE
1. Use the LINE key to switch between the positive (+) or the nega-
tive (-) selection. A positive selection moves the vertical base refe-
rence point forward (away from the print mechanism) while a
negative selection moves the vertical base reference point back
into the mechanism.
2. Once the correct setting is underlined,
press the FEED key to accept the set-
ting and advance to the adjustment.
3. Use the LINE key to step the counter to the desired position. The
display will increment one step for each time the LINE keyispres-
sed. If the LINE key is held down for more then two seconds, it will
automatically go into the fast scroll mode (max. 400).
4. Once the setting is correct, press the FEED key to accept the set-
ting and advance to the Horizontal Offset adjustment.
5. You may wish to check your settings by printing a test label after
you have completed the adjustments to ensure that they are cor-
rect.
SPEED
123
V:OFFSET
V:±0000
V:OFFSET
V:±0000