Specifications

14 DR300
1. Overview and Specifications Operation Manual
Printer Main Body Operation Unit
1.4 Ribbon
Use only SATO thermal transfer ribbons which were formulated
expressly for use in all SATO printers. Use of other than approved
ribbons may result in unsatisfactory print quality and/or damage to
the print head and may void your warranty.
1.5 Installation Considerations
Printer operation can be affected by the printer environment. The
location of the printer should be free from dust, humidity, and sud-
den vibrations. To obtain optimum results from the printer, avoid
locations influenced by:
• Direct or bright sunlight since bright light will make the label sen-
sor less responsive and may cause the label to be sensed incor-
rectly.
• Warm temperatures which can cause electrical problems within
the printer.
LCD display
unit
8 x 2 lines LCD display is activated when touch screen is
not connected.
Operation key Feed key Paper feeding
Line key Temporary halts printing (print pause)
LED 2 color LED RED : error display
GREEN: On-Iine
DIP Switch DIPSW 1 Serial interface (Setting baud rate, etc.)
DIPSW 2 Setting operation mode, etc.
Setting Hex dump function
DIPSW 3 Setting zero slash and non-standard proto-
code
Variable
control VR
PITCH Pitch adjustment
OFFSET Cutter, dispense, tear off position adjustment
PRINT Print darkness adjustment