User`s guide

Section 5. Configuration Commands
Page 5-6 PN 9001106(B) SATO CX400 / CX410
Label Tear-Off
COMMAND STRUCTURE <ESC>CBabb
a = + moves print line down from the top label edge
- moves print line up towards the top label edge
bb = Distance moved in mm (00 to 98)
Example: <ESC>CB+19
Placement: Separate data stream sent to printer
Default: Last valid setting
COMMAND FUNCTION To adjust the location of the first print line on the label.
INPUT TO PRINTER <ESC>A
<ESC>CB+19
<ESC>Z
PRINTER OUTPUT There is no printer output for this command.
SPECIAL NOTES 1. The effects ofthis command are absolute, i.e. if an <ESC>CB+06
command is followed by an <ESC>CB-02, the resulting position is -
02 mm.
2. The maximum range for the value stored in the printer is 98 mm.
Any commands received that causes the value to exceed 00 or 98
mm will result in a setting of 00 or 98 mm respectively.
3. This value is stored in non-volative memory and will remain until it
is modified by another valid <ESC>CBabb command, even if
power is removed from the printer.
4. The current setting is printed on the “Pitch Offset” line on the Test
Label.