Technical information

CX400 Technical Manual (Rev 1.00)
SATO /ARGOX Technical Documentation
Confidential Information
33
9. Take out “ E Ring ( X )” to remove Gear (67) .
10. Loose Screw ( B ).
11. Take out the 2 “BUSH -ROOLER” ( 26 ) which ringed the ROLLER (27 ) shaft .
12. Move ROLLER ( 27 ) to the most left side then pull it out. Then take out the BUSH-ROLLER (26) which is adhered to the
Right Shaft of ROLLER(27).
13. Put the BUSH -ROLLER, which take out from step 11,into the right shaft ( Shorter one ) of new ROLLER.
14. Put the Left Shaft of new ROLLER (27)( Longer shaft ) into the Roller Hole at the left side of “Printer Chassis”, then push
the right Shaft( Shorter Shaft ) into the Roller Hole at the right side of “Printer Chassis”(30).
15. Put 2 BUSH-ROLLER (26 ) into the left Shaft of New ROLLER ( 27 )
16. Fix New “ROLLER”(27) in “Printer Chassis”(30) with Screw (B ).
17. Put back Gear ( 67 ) then fix it with “E ring “.
18. Let the 2 Power Cords go through the switch hole on “Middle Cover”(96), then plug “Power Cord” to “Power Switch”.
19. Pull the front side of “ middle cover” to put it back on “Bottom” (39).
20. Screw up 2 screws(I) on Printer Bottom.
21. Push righ “ANG-PEELER”(28) to put it into “Printer Chassis”(30).
22. Fix “ANG-PEELER” to “Printer Chassis”(30) with “SCREW (E )” .
23. Screw up 2 screws( B ) to fix “Peeler Cover”(75) on “Printer Chassis”(30).
24. Press and click “Power Switch” into the switch hole on “Middle Cover”(96).
Fig. 8.8