Technical information

CX400 Technical Manual (Rev 1.00)
SATO /ARGOX Technical Documentation
Confidential Information
30
7. Loose 4 screws ( E ).
8. Unplug all the connectors which connected on Main Board . Then take out the “Printer Chassis” ( 30 ) .
9. Loose those 4 screws ( B ) which fixed Main-Board (80) on Bottom ( 39 ). Then take out the Bad Main-Board.
10. Put the new main on Bottom(39). Then Screw up those 4 screws ( B ) on Printer Bottom ( 39).
11. Plug the female connectors, which attached on “Printer Chassis”( 30 ) with cables, into the corresponding male connectors
( Its color & Pin Count are identical with the female connector ) on Main Board.
12. Put “Printer Chassis”(30) on Bottom(39).
13. Screw up 4 screws (E ) to fix “Printer Chassis” (30 ) on Bottom(39).
14. Let the 2 Power Cords go through the switch hole on “Middle Cover”(96), then plug “Power Cord” to Power Switch.
15. Pull the front side of “middle cover ” to put it back on “Bottom” (39).
16. Screw up the 2 screws(I) on Printer Bottom.
17. Screw up the 2 screws( B ) to install “Peeler Cover”(75) on “Printer Chassis”(30).
18. Press and click “Power Switch” into the switch hole on “Middle Cover”(96).
Figure 8.5