Technical information

CX400 Technical Manual (Rev 1.00)
SATO /ARGOX Technical Documentation
Confidential Information
25
< III.. RS232 Error >
LED Signal Status Cause
“POWER LED ON” and “ERROR
LED blinking at 50 % duty cycle “
RS232 Error 1.
The Settings for RS232 between Host & Printer
are not consistent
Switch power off
Is baud rate
consistent in PC
& Printer?
Yes
Yes
Set the same Baud
Rate in PC & Printer
?
?
No
No
No
Switch power on
then print
Is Data Bit
consistent in PC
& Printer?
Is Parity bit
consistent in PC
& Printer?
Set the same Data
Bit in PC & Printer
Set the same Parity
Bit in PC & Printer