Technical information

CX400 Technical Manual (Rev 1.00)
SATO /ARGOX Technical Documentation
Confidential Information
16
9. Let the 2 Power Cords go through the switch hole on “Middle Cover”, then plug “Power Cord” to Power Switch.
10. Pull the front side of “ middle cover” to put it back on “Bottom” (39).
11. Screw up the 2 screws(I) on Printer Bottom.
12. Plug the cutter cable to “External Connector” as shown on Figure 6-3.
13. Insert “Cutter Module” into the slot on “Printer Chassis”(30) where you took off “ANG-PEELER”(28)
in “step 4”.
14. Screw “Cutter Module “ on “Printer Chassis”(30) wit h screw (B).
15. Click back “Print Head” and Click back “Top Cover”
16. After cutter had been installed well with the above steps, you still need to set the E2PROM through commands.
<esc>A
<esc>CK1
<esc>Z
Once the cutter is uninstalled you also need change the setting by commands or make a reset from panel.
<esc>A
<esc>CK0
<esc>Z
Figure 6-3