Technical information

CX400 Technical Manual (Rev 1.00)
SATO /ARGOX Technical Documentation
Confidential Information
14
6. OPTIONAL PARTS INSTALLATIONS
CAUTION
The printer electronics are susceptible to static discharge . Wear
an anti-static wrist and attach it to the printer chassis
6.1 Cutter Installation
1. Turn off the power switch
2. Loose the 2 screws( B ) to take off “Peeler Cover”(75).
3. Loose the screw ( E) which screwed “ANG-PEELER” (28) to “Printer Chassis”(30).
4. Push “ANG-PEELER”(28) to right then take it out.
Figure 6. 1