Technical information

CX400 Technical Manual (Rev 1.00)

SATO /ARGOX Technical Documentation

Confidential Information

Or you are also able to directly send out a group of commands to printer for calibrating the media sensors in either I-

mark(Reflective )or Gap(See-Through ) mode. Two groups of commands for Bar & Gap mode sensor are listed below,

 <ESC>A

<ESC >CI1

<ESC>CA

<ESC>Z

< In Gap mode >

<ESC>A

<ESC>CI2

<ESC>CA

<ESC>Z

3. Once the Media sensor calibration is activated in step 2, the printer will feed several labels ( 6 inches) to perform this

calibration. After this printer completely stops feeding label, this calibration had been well.

< note 1 > < ESC> = 0x1B,

< note 2 > The ribbon must be installed in the printer when calibrating in the thermal transfer mode.

Figure 5.2

Media Sensor

Ribbon Sensor

Print Head(TPH)

Printhead Open Sensor