Specifications
Table Of Contents
- Consumables
- Conventions
- Warranty and Copyright
- Contents
- CX SERIES PROGRAMMING GUIDE
- INTRODUCTION
- THE SATO PROGRAMMING LANGUAGE
- SELECTING PROTOCOL CONTROL CODES
- USING BASIC
- Printing with the Parallel Port
- Printing with the RS232 Port
- ROTATED FIELDS
- COMMAND DEFAULT SETTINGS
- PRINTER CONFIGURATION
- COMMAND CODE PAGE REFERENCE
- Bar Codes
- Bar Codes, Expansion
- Bar Codes, Variable Ratio
- Base Reference Point
- Characters, Custom-Designed
- Character Expansion
- Character, Fixed Spacing
- Character Pitch
- Character, Proportional Spacing
- Clear Print Job(s) & Memory
- Continuous Forms Printing
- Copy Image Area
- Cutter Command
- Fonts U, S, M, OA, OB, XU, XS & XM
- Fonts WB, WL, XB & XL
- Form Feed
- Form Overlay, Recall
- Form Overlay, Store
- Graphics, Custom
- Graphics, PCX
- Journal Print
- Label Size & Start Position
- Lines and Boxes
- Line Feed
- Off-Line/Pause
- Postnet
- Print Darkness
- Print Length, Expanded
- Print Position
- Print Quantity
- Print Speed
- Repeat Label
- Replace Data (Partial Edit)
- Reverse Image
- Rotate, Fixed Base Reference Point
- Rotate, Moving Base Reference Point
- Sequential Numbering
- Start/Stop Label
- Expanded Memory Option Commands
- Expanded Memory Function Fonts, TrueType Recall
- Expanded Memory Function Fonts, TrueType Store
- Expanded Memory Function Graphics, Custom Recall
- Expanded Memory Function Graphics, Custom Store
- Expanded Memory Function Graphics, PCX Recall
- Expanded Memory Function Graphics, PCX Store
- Expanded Memory Function Initialise
- Expanded Memory Function Area Select
- Expanded Memory Function Status
- Two-Dimensional Symbols
- Two-Dimensional Bar Codes Maxicode
- Two-Dimensional Bar Codes PDF417
- CONFIGURATION COMMANDS
- Calibrate Sensor
- Auto Calibration
- Custom Protocol Command Codes Download
- Label Tear-Off
- Print Darkness Fine Adjustment
- Print Test Label
- Set Print Mode
- Set RS232 Parameters
- Set Sensor Type
- Back Feed Enable
74
SATO CX Series Printer
Expanded Memory Option Commands
Expanded Memory Option CommandsExpanded Memory Option Commands
Expanded Memory Option Commands
These commands require the Expanded Memory Option.
The first 2MB of Expanded Memory installed is designated as memory area
CC1.If 4MB of Expanded Memory is installed, second 2MB (i.e. the area
above the first 2 MB) is designated as memory area CC2.
IMPORTANT:-
Please note that the Expanded Memory
Option Commands are not yet imple-
mented.
Please contact SATO Europe Technical
Department for the latest information.