Specifications
Table Of Contents
- Consumables
- Conventions
- Warranty and Copyright
- Contents
- CX SERIES PROGRAMMING GUIDE
- INTRODUCTION
- THE SATO PROGRAMMING LANGUAGE
- SELECTING PROTOCOL CONTROL CODES
- USING BASIC
- Printing with the Parallel Port
- Printing with the RS232 Port
- ROTATED FIELDS
- COMMAND DEFAULT SETTINGS
- PRINTER CONFIGURATION
- COMMAND CODE PAGE REFERENCE
- Bar Codes
- Bar Codes, Expansion
- Bar Codes, Variable Ratio
- Base Reference Point
- Characters, Custom-Designed
- Character Expansion
- Character, Fixed Spacing
- Character Pitch
- Character, Proportional Spacing
- Clear Print Job(s) & Memory
- Continuous Forms Printing
- Copy Image Area
- Cutter Command
- Fonts U, S, M, OA, OB, XU, XS & XM
- Fonts WB, WL, XB & XL
- Form Feed
- Form Overlay, Recall
- Form Overlay, Store
- Graphics, Custom
- Graphics, PCX
- Journal Print
- Label Size & Start Position
- Lines and Boxes
- Line Feed
- Off-Line/Pause
- Postnet
- Print Darkness
- Print Length, Expanded
- Print Position
- Print Quantity
- Print Speed
- Repeat Label
- Replace Data (Partial Edit)
- Reverse Image
- Rotate, Fixed Base Reference Point
- Rotate, Moving Base Reference Point
- Sequential Numbering
- Start/Stop Label
- Expanded Memory Option Commands
- Expanded Memory Function Fonts, TrueType Recall
- Expanded Memory Function Fonts, TrueType Store
- Expanded Memory Function Graphics, Custom Recall
- Expanded Memory Function Graphics, Custom Store
- Expanded Memory Function Graphics, PCX Recall
- Expanded Memory Function Graphics, PCX Store
- Expanded Memory Function Initialise
- Expanded Memory Function Area Select
- Expanded Memory Function Status
- Two-Dimensional Symbols
- Two-Dimensional Bar Codes Maxicode
- Two-Dimensional Bar Codes PDF417
- CONFIGURATION COMMANDS
- Calibrate Sensor
- Auto Calibration
- Custom Protocol Command Codes Download
- Label Tear-Off
- Print Darkness Fine Adjustment
- Print Test Label
- Set Print Mode
- Set RS232 Parameters
- Set Sensor Type
- Back Feed Enable
SATO CX Series Printer
27
Clear Print Job(s) & Memory
Clear Print Job(s) & MemoryClear Print Job(s) & Memory
Clear Print Job(s) & Memory
Command Structure
<ESC>*a
a = Specifies the internal memory section to be
cleared.
T To clear the custom character memory
& To clear the form overlay memory
X To clear all internal memory
Example: <ESC>*
<ESC>*&
Placement: This command should be sent to the printer as
an independent data stream.
Default: None
Command Function
To clear individual memory or buffer areas of the printer.
Input to Printer:
<ESC>A
<ESC>*
<ESC>Z
Printer Output:
There is no printer output as a result of this command. The
current print job in the buffer will be terminated and all other
print jobs in the buffer cleared.
Special Note
1. It is not necessary to clear the printer’s memory between
each print job.
2. When the “a” parameter is used, the section of memory
specified will not be cleared until the label is printed.
3. When the “a” parameter is not included, all sections of
memory will be cleared the same as for the <ESC>*X
command.