Specifications
Table Of Contents
- Consumables
- Conventions
- Warranty and Copyright
- Contents
- CX SERIES PROGRAMMING GUIDE
- INTRODUCTION
- THE SATO PROGRAMMING LANGUAGE
- SELECTING PROTOCOL CONTROL CODES
- USING BASIC
- Printing with the Parallel Port
- Printing with the RS232 Port
- ROTATED FIELDS
- COMMAND DEFAULT SETTINGS
- PRINTER CONFIGURATION
- COMMAND CODE PAGE REFERENCE
- Bar Codes
- Bar Codes, Expansion
- Bar Codes, Variable Ratio
- Base Reference Point
- Characters, Custom-Designed
- Character Expansion
- Character, Fixed Spacing
- Character Pitch
- Character, Proportional Spacing
- Clear Print Job(s) & Memory
- Continuous Forms Printing
- Copy Image Area
- Cutter Command
- Fonts U, S, M, OA, OB, XU, XS & XM
- Fonts WB, WL, XB & XL
- Form Feed
- Form Overlay, Recall
- Form Overlay, Store
- Graphics, Custom
- Graphics, PCX
- Journal Print
- Label Size & Start Position
- Lines and Boxes
- Line Feed
- Off-Line/Pause
- Postnet
- Print Darkness
- Print Length, Expanded
- Print Position
- Print Quantity
- Print Speed
- Repeat Label
- Replace Data (Partial Edit)
- Reverse Image
- Rotate, Fixed Base Reference Point
- Rotate, Moving Base Reference Point
- Sequential Numbering
- Start/Stop Label
- Expanded Memory Option Commands
- Expanded Memory Function Fonts, TrueType Recall
- Expanded Memory Function Fonts, TrueType Store
- Expanded Memory Function Graphics, Custom Recall
- Expanded Memory Function Graphics, Custom Store
- Expanded Memory Function Graphics, PCX Recall
- Expanded Memory Function Graphics, PCX Store
- Expanded Memory Function Initialise
- Expanded Memory Function Area Select
- Expanded Memory Function Status
- Two-Dimensional Symbols
- Two-Dimensional Bar Codes Maxicode
- Two-Dimensional Bar Codes PDF417
- CONFIGURATION COMMANDS
- Calibrate Sensor
- Auto Calibration
- Custom Protocol Command Codes Download
- Label Tear-Off
- Print Darkness Fine Adjustment
- Print Test Label
- Set Print Mode
- Set RS232 Parameters
- Set Sensor Type
- Back Feed Enable
98
SATO CX Series Printer
A Protocol Command code status label will be printed as a re-
sult of the a successful download of a custom set of Protocol
Command codes.
Special Notes:
1. Commas must be used to separate the parameters. If a
parameter is omitted between two commas, the default
Non-Standard Protocol Command codes for that para-
meter will be used.
2. This command must be sent as an independent data
stream immediately following the <ESC>A Start code
and immediately preceding the <ESC>Z Stop code. No
other commands can be included in the data stream.
3. If more or less than nine commas are included in the
command, the entire command sequence will be igno-
red. The command must contain exactly nine commas.
4. If two characters are specified for a parameter, it will be
interpreted as a hex value.
5. If a combination of characters are outside the hexadeci-
mal range, the entire command sequence will be igno-
red.
6. The current protocol command codes may be verified by
printing a self test label (<ESC>CT).
STX=7B
ETX=7D
ESC=25
ENQ=23 CAN=26 NULL=2A
OFFLINE=7E
Press the "FEED" key to activate the User
Defaults, or Power OFF to ignore them.