Specifications
Table Of Contents
- Consumables
- Conventions
- Warranty and Copyright
- Contents
- CX SERIES PROGRAMMING GUIDE
- INTRODUCTION
- THE SATO PROGRAMMING LANGUAGE
- SELECTING PROTOCOL CONTROL CODES
- USING BASIC
- Printing with the Parallel Port
- Printing with the RS232 Port
- ROTATED FIELDS
- COMMAND DEFAULT SETTINGS
- PRINTER CONFIGURATION
- COMMAND CODE PAGE REFERENCE
- Bar Codes
- Bar Codes, Expansion
- Bar Codes, Variable Ratio
- Base Reference Point
- Characters, Custom-Designed
- Character Expansion
- Character, Fixed Spacing
- Character Pitch
- Character, Proportional Spacing
- Clear Print Job(s) & Memory
- Continuous Forms Printing
- Copy Image Area
- Cutter Command
- Fonts U, S, M, OA, OB, XU, XS & XM
- Fonts WB, WL, XB & XL
- Form Feed
- Form Overlay, Recall
- Form Overlay, Store
- Graphics, Custom
- Graphics, PCX
- Journal Print
- Label Size & Start Position
- Lines and Boxes
- Line Feed
- Off-Line/Pause
- Postnet
- Print Darkness
- Print Length, Expanded
- Print Position
- Print Quantity
- Print Speed
- Repeat Label
- Replace Data (Partial Edit)
- Reverse Image
- Rotate, Fixed Base Reference Point
- Rotate, Moving Base Reference Point
- Sequential Numbering
- Start/Stop Label
- Expanded Memory Option Commands
- Expanded Memory Function Fonts, TrueType Recall
- Expanded Memory Function Fonts, TrueType Store
- Expanded Memory Function Graphics, Custom Recall
- Expanded Memory Function Graphics, Custom Store
- Expanded Memory Function Graphics, PCX Recall
- Expanded Memory Function Graphics, PCX Store
- Expanded Memory Function Initialise
- Expanded Memory Function Area Select
- Expanded Memory Function Status
- Two-Dimensional Symbols
- Two-Dimensional Bar Codes Maxicode
- Two-Dimensional Bar Codes PDF417
- CONFIGURATION COMMANDS
- Calibrate Sensor
- Auto Calibration
- Custom Protocol Command Codes Download
- Label Tear-Off
- Print Darkness Fine Adjustment
- Print Test Label
- Set Print Mode
- Set RS232 Parameters
- Set Sensor Type
- Back Feed Enable
94
SATO CX Series Printer
CONFIGURATION COMMANDS
CONFIGURATION COMMANDSCONFIGURATION COMMANDS
CONFIGURATION COMMANDS
The following commands are used to set the operating parameters of the CX
Series printers. The settings currently active in the printer can be determined
by printing a Test Label, either by using the <ESC>CT Print Test Label com-
mand or by pressing the READY Indicator and FEED buttons on the front panel
(see the CX Series User’s Guide).