Specifications

32 CL608e/612e
4. Media Loading Operation Manual
Step 6 When using fanfold labels (or tags) set them on a flat
surface behind the printer. Pass the labels (printing
side up) through the slot and under the label unwind
bracket.
Step 7 Open the feed roller assembly by squeezing the
green tab and the release tab together. The feed
roller assembly is spring loaded and will open auto-
matically when the latch is disengaged. Feed the
labels under the label guide shaft, under the feed
roller assembly, through the print head assembly
and out the front of the printer.
Step 8 Inspect the label route and check that the path
matches that illustrated in the label loading diagram.
Set the adjustable label guides to keep the labels
against the backplate of the printer.
Step 9 Close the feed roller assembly by pushing downward
on the green tab until it latches closed.
Note: When the label dispenser option has been
installed, remove 600 to 800 mm of labels from
the backing and feed the backing back through
the label dispense path.
Label Guide Shaft
Feed Roller
Assembly
Head Assembly
Label Unwind
Guides