Specifications

Operation Manual 3. Configuration
CL608e/612e 25
3.2 Default Settings
Switch Selections
All switches except DSW2-5 are placed in the OFF position
(default) for shipping. This will result in the following operating con-
figuration:
• Communications: 8 data bits, no parity, 1 Stop bit, 9600 Baud
• Protocol: Ready/Busy
• Sensor: Gap Sensor
• Receive Buffer: Multi Job
• Mode: Batch/continuous
• Pitch: Sensor Used
• Back feed: Enabled
• External Signals: Disabled
Software Default Settings
The printer stores the software settings upon receipt and uses
them until they are again changed by receipt of a command con-
taining a new setting. These settings are stored in non-volatile
RAM and are not affected by powering the printer off. The printer
may be reset to use the default software settings by depressing the
LINE and FEED keys simultaneously while powering the printer on.
This will result in the following default configuration:
• Print Darkness: "2"
• Print Speed: 6 inches per second
• Print Reference: Vertical = 0000, Horizontal = 0000
• Zero: Slash
• Auto On Line: Enabled
• Ignore CR/LF: Disabled
• Character Pitch: Proportional
• Auto Online Feed: Disabled
• Feed On Error: Disabled
• Repeat Print: Disabled
• Forward/Backfeed: Standard
• Select Language: English
• Priority Setting: Command