Specifications

Operation Manual 3. Configuration
CL608e/612e 13
3. Printer Configuration
3.1 DIP Switch Settings
Two DIP switches DSW2 and DSW3 are located under the front
cover panel and a DSW1 switch is located on an optional RS232
serial interface board.
These switches can be used to set:
• RS232C transmit/receive parameters
• Thermal transfer or direct thermal mode
• Label sensor enable/disable
• Head check mode
• Hex dump mode
• Receive buffer size
• Operation mode
To set the switches, first power the unit Off, then position the DIP
switches. After placing the switches in the desired positions, power
the printer back on. The switch settings are read by the printer
electronics during the power up sequence. They will not become
effective until the power is cycled.
DIP Switch Panel Layout for DSW1
Located on RS232 Interface Board