Specifications

6 CL608e/612e
2. Introduction Operation Manual
LEDs:
POWER: LED illuminated when the power is on.
LABEL: LED illuminated when label supply is out.
RIBBON: LED illuminated when ribbon motion sensor does not
detect any ribbon motion.
ERROR: LED illuminated when there is a system fault such as
open print head, interface or system error.
ONLINE: LED illuminated when printer is ready to receive data. It
is turned on and off by toggling the LINE key.
Push-buttons:
LINE Push-button. Pressing this key toggles the printer between
the On-Line and Off-Line mode. When the printer is On-Line, it is
ready to receive data from the host. This key can act as a pause
during a print job, by taking the printer Off-Line.
FEED Push-button. Pressing this key feeds one blank label through
the printer when it is Off-Line. When the printer is On-Line, the last
label of the print buffer will be repeated.
DIP switches:
DSW: DIP switch array to set operational parameters of printer.
Potentiometers:
PRINT (VR1): Potentiometer to adjust print darkness (fine tuning).
OFFSET (VR2): Potentiometer to adjust amount of back/forward
feed for dispenser or cutter function (± 3.75mm). Independent from
pitch adjustment.
PITCH (VR3): Potentiometer to adjust home position of the label (±
3.75mm). After the media pitch has been set using the pitch offset
adjustment in the user mode, it is sometimes desirable to make
minor adjustments. This can be done by using the PITCH potenti-
ometer on the operation panel. This potentiometer is set at the fac-
tory so that it has a range of ± 3.75mm. The midpoint setting should
have no effect on the pitch. Turning the potentiometer all the way
clockwise (minus offset) should move the print position 2.0mm up
towards the top edge of the label. Turning it all the way counter-
clockwise (plus offset) should move the print position down 2.0mm.
Affects stop position of label feed, print position and dispense posi-
tion.
DISPLAY (VR4): Display contrast