User manual

SAP Device Driver for SATO Printers 49-62
User Manual
90 degree
Text Rotation
ROTATE_90_x
Name of
Window to
be rotated
ESC+%1
x is any number to
make sure the
command name is
not repeated in the
SmartForms
180 degree
Text Rotation
ROTATE_180_x
Name of
Window to
be rotated
ESC+%2
x is any number to
make sure the
command name is
not repeated in the
SmartForms
270 degree
Text Rotation
ROTATE_270_x
Name of
Window to
be rotated
ESC+%3
x is any number to
make sure the
command name is
not repeated in the
SmartForms
Page Number
PRINT_QUANTITY
Number of
pages to
print
ESC+Q
It is print command
is not specified, the
page is printed
once. Example of
the value:
'%PAGE2:4'
This means the
page with name
“%PAGE2” will be
printed 4 times.
Subsequent page
number can be
added with a
comma separator.
For example,
'%PAGE2:4,
%PAGE3:3' This
means page
‘%PAGE2’ is
printed 4 times and
page ‘%PAGE3’ is
printed 3 times
Print
Darkness
(#F command)
PRINT_DARKNESS_F
ab,
a: 1~ 10
b: A~F
ESC+#F
This commands for
supported models
SG400R-ex,
SG600R and
SG112R.
Print Motion
Mode
PRINTMOTION_MODE
0-8
ESC+PM
To specify motion
mode temporarily.
Print Off-set
LABELSTOP_OFFSET
abcc,
a: 0~3
b: +/-
c:00~99(dot)
ESC+PO
To specify
adjustment of label
stop position during
every motion
temporarily.
Table 8 System Commands
It is important to refer to the command specification of the printer models to understand the
correct range of value can be used for the Command values. Note that the Command Names
are case-sensitive.
System command should be used carefully. Invalid input may result in unexpected outcome of