Instruction manual
Table Of Contents
- Safety Precautions
- Precautions for Installation and Handling
- Select a Safe Location
- Power Supply
- Checking Accessories
- About the Box
- Power Setting
- 1. Connect the AC power cord to the AC adapter.
- 2. Connect the printer to the AC adapter. Connect the AC adapter to the AC power outlet. When connecting the DC power cord to the printer’s power connector, make sure the DC power cord connector is oriented properly. When connecting the DC power co...
- 3. Press the POWER button on the operation panel of the printer. The ON LINE (POWER) lamp is on. Check that the ON LINE (POWER) lamp is on.
- 4. Press the POWER button to turn off the printer. When the power is off, the ON LINE (POWER) lamp turns off.
- Basic Specifications
- Asia Pacific & Oceania Region
- European Region
- American Region
- SATO Group of Companies
Section 1: Names of Parts
Page 1-4 CG4 Series Quick Guide
Internal view when Top cover is opened
CG408DT/ CG412DTCG408TT/ CG412TT
15
20
16
17
18
19
21
22
15
18
20
19
21
22
Print head
This component is used to print on the media.
Perform maintenance at regular intervals.
Ribbon unit
Used to load the ribbon and wind up the used
ribbon.
Pull out lever
This is used to pull out the ribbon unit from the
top cover for ribbon loading.
Roll media holder
To hold the roll media.
Media guide slide lever
Set to meet the size of the media used.
Media guide and I-Mark/ Gap sensor
A guide for the media to feed properly.
Detects the I-Mark on the media or gap of the
label.
Platen roller
This roller feeds the media. Perform
maintenance at regular intervals.
Optional device compartment
Used to install optional cutter or dispenser unit.
15
15
16
16
17
17
18
18
19
19
20
20
21
21
22
22