Instruction manual

Section 7: Interface Specifications
Page 7-12 CG4 Series Operator Manual
7.5 LOCAL AREA NETWORK (LAN) ETHERNET (cont’d)
7.5.2 Software Specifications
ProtocolTCP/IP
Network layerARP, RARP, IP, ICMP
Session layerTCP, UDP
Application layerLPR, FTP, TELNET, BOOTP, DHCP, HTTP
Notes
• Send the print data by LPR and FTP of TCP/IP and dedicated socket protocol. (STATUS3, Protocol for
driver (STATUS4))
• Use socket connection to get the printer status.
Communication
configuration
The following settings can be configured via the Printer configuration tool or com-
mands.
Item Command Setting range
LAN mode <I3> Protocol for driver (STATUS4) cyclic
response mode *
1
Protocol for driver (STATUS4) ENQ
response mode *
1
STATUS3 *
2
IP address <W1> 0.0.0.0 ~ 255.255.255.255
Subnet mask <W2> 0.0.0.0 ~ 255.255.255.255
Gateway address <W3> 0.0.0.0 ~ 255.255.255.255
IP address setup <WI> Manual
DHCP
RARP <WM> RARP disabled
RARP enabled
*
1
*
2
2-port connection by Port1024 and Port1025 or 1 port connection by
Port9100.
1 port connection by Port1024 or Port9100.
Maximum receive
buffer capacity
1MB
Buffer near full
Buffer near full
0MB
1MB
Remaining 0.25MB
Remaining 0.5MB
occurred
released