User's Manual
30 49-70-020-DOC 21-Sep-10
User Manual
MSTRP Tunnel Readers
Mains Input: 110 - 240 VAC @ 50/60 Hz
Power Consumption: 125 W
Operation environment: Indoor use
Temperature range: +10°C to +45°C
Humidity: 10% to 80% (non-condensing)
Recommended Minimum Host Computer Requirement:
Windows XP SP2/ 500 MHz CPU/ 128MB RAM
Host Interface: USB and Ethernet
6.3 RegulAtion And stAndARds
RFID equipment is subject to national and international regulations.
6.3.1 fCC RAdio fRequenCy inteRfeRenCe stAtement (usA)
The FCC regards RFID equipment as low-power transmitting devices and, therefore, does not require users of RFID
devices to obtain a license to operate them.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorientation or relocation of receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Any changes or modications to the equipment that are not expressly approved by the party responsible for
compliance could void the user’s authority granted under FCC Rules to operate this equipment.
FCC ID: TVN-STRP
•
•
•
•
•
•
•
•
•
•
•
•