User's Manual

16 49-70-020-DOC 21-Sep-10
User Manual
MSTRP Tunnel Readers
4.2.4 ConneCting multiple ReAdeRs to A loCAl netWoRk
Multiple readers can be connected to a local network using an Ethernet hub/switch. Plug the Ethernet communication
cable into the MSTRP-5050/MSTRP-6464 Ethernet port and Ethernet hub/switch.
Always connect the Ethernet cable before power is applied to the reader.
4.2.5 leds
When power is applied to the MSTRP-5050/MSTRP-6464 reader the LEDs should operate as follows:
the green Axis, Power and Channel LEDs will come on immediately
then they will go o in about 1 minute
the green Axis and Power LEDs will come on again in 1-3 seconds and remain permanently lit indicating
that the unit is in an operational mode; the green Channel LED will be o
1.
2.
3.
Axis LEDs
User controlled
output LEDs
Warning LED
Channel LEDs
Power LED