User's Manual

13-Nov-07 49-70-020-DOC 3549-70-020-DOC 35 35
MSTRP-5050 (MC 5/6)
User Manual
6.3 RegulAtion And stAndARds
RFID equipment is subject to national and international regulations.
6.3.1 fCC RAdio fRequenCy inteRfeRenCe stAtement (usA)
The FCC regards RFID equipment as low-power transmitting devices and, therefore, does not require users of
RFID devices to obtain a license to operate them.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorientation or relocation of receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Any changes or modications to the equipment that are not expressly approved by the party responsible for
compliance could void the user’s authority granted under FCC Rules to operate this equipment.
FCC ID: TVN-MSTRP
6.3.2 industRy CAnAdA RAdio fRequenCy inteRfeRenCe deClARAtion of ConfoRmity
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
ICES\NMB-003 IC: 6569A-MSTRP
This apparatus complies with ETSI EN 301 489-1 RF common mode immunity requirements on Ethernet Port
with shielded CAT5 Ethernet Cable.
Intended use of the equipment is as a Reader to read and write information to multiple or individual tags.
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
•
•
•
•