User's Manual

 Customers can replace or add additional
information to the Model Name-Serial Number
such as a physical location or customer ID
number. Refer to section 3.5.4 Changing the
Reader’s Network Setup of this User Manual.
 Subsequently when a customer starts using
the Reader the new name will appear on the
list of Readers in the Connection menu.
 Tip: If you want to use the new name
immediately, simply unplug the power
connector and plug in again to view the new
name on the Connection menu list.
When a Reader is connected to a host computer for the first time using a
USB cable, there are a few more steps to go through before
ReaderManager is able to identify a new Reader:
1. In Found New Hardware Wizard tick Yes,
this time only to search for software and
press Next.
2. In What do you want wizard to do? tick
Install the software automatically and
press Next.
3. Wait while the wizard installs the
software: Linux USB Ethernet/RNDIS
Gadget. Ignore other message and press
Continue anyway.
4. Press Finish.
5. Open the Connection menu to see a list
of Readers and the new Reader identified
by Model Name-Serial Number on the list.
6. If you can not find the new Reader on the
list simply unplug the USB cable and plug
it again into the Reader USB device port.
This time you should be able to see the
Reader’s Model Name-Serial Number.
Step 2. Click the Connection menu item to view Readers found on the local network.
ReaderManager will use network broadcasts to look for active readers via
USB and Ethernet. If you click on the Connection menu, you can see
readers defined in there automatically.
A list of Readers will be displayed as shown below. The IP address and
MAC address will be shown on the status bar as you move the mouse over
each Reader entry.
MDR-1109 USER MANUAL 60-70-002-DOC ver.1 18