User's Manual

3.3 Hardware Installation
USB device port USB host port
Power port RJ45
(Ethernet port)
MDR-1109 connector panel
Step 1. Connect a low voltage power pack to the unit.
The connection to the power source is realized via a low voltage power
pack.
The power cable is not supplied with the Reader
and recommended to be purchased in the country
of use.
MDR-1109 with plugged-in low voltage power cable
Step 2. Plug the power supply into AC power mains. LEDs will come on.
When power is applied to an MDR-1109 Reader the LEDs on the unit
should operate as follows:
 the red LED and green LED will immediately come on; both LEDs will
go off in about 1 minute
MDR-1109 USER MANUAL 60-70-002-DOC ver.1 13