User's Manual

4.1.1Connecting to a power supply

Step 1. Connect a low voltage power pack to the unit.

The connection to the power source is realized via a low voltage power

pack.

The power cable is not supplied with the Reader

and recommended to be purchased in the country

of use.

Step 2. Plug the power supply into AC power mains.

When power is applied to a MARS-24 Reader the LEDs on the Reader

should operate as follows:

 the blue LED and green LEDs will immediately come on; both LEDs

will go off in about 1 minute

MARS-24 with the blue and green LEDs on

 the blue LED will come on again in 1-3 seconds indicating that the

unit is in an operational mode; the green LEDs will be off

MARS-24 with the blue LED. The Reader is in an operational mode

 once the unit is in an operational mode the blue LED will remain lit

the green LEDs will flash every time a tag/tags is/are successfully

read

MARS-24 USER MANUAL 63-70-006-DOC ver.1