User's Manual

4.1.1Connecting to a power supply
Step 1. Connect a low voltage power pack to the unit.
The connection to the power source is realized via a low voltage power
pack.
The power cable is not supplied with the Reader
and recommended to be purchased in the country
of use.
Step 2. Plug the power supply into AC power mains. LEDs will come on.
When power is applied to an MARS Reader the LEDs on the Reader should
operate as follows:
 the red LED and green LED will immediately come on; both LEDs will
go off in about 1 minute
MARS with the red and green LEDs on
 the red LED will come on again in 1-3 seconds indicating that the
Reader is in an operational mode; the green LED will be off
MARS with the red LED. The Reader is in an operational mode
MARS-1-2-4-6 USER MANUAL 64-70-017-DOC ver.1
23