User Guide

Reader Manager Guide Page 40 of 62 40-10-006-DOC 15/09/2006
4. Click Tune Axis.
6.8.6 Setup axis tuning
This form provides instructions for tuning the antenna connected to each axis port.
The Setup axis tuning form is shown in Figure 29 and its elements are detailed in Table 16.
Figure 29
Index Description
1 Setup progress – should show Save configuration as being complete.
2 Current axis indicator.
3 Tuning instructions for the current axis / antenna.
4
Enter the voltage measured on the tuning block. This is not saved to the reader or to disk it is included only as
information which is shown on the final summary form.
5 Click this to go back to the Save configuration form.
6 Click this to setup the previous axis.
7 Click this to setup the next axis.
8 Click this to go to the Test axis form.
Table 16
Typical usage of this form is:
1. Follow the tuning instructions.
2. Enter the maximum voltage measured when tuning the antenna.
3.
Click Next to tune the next switch to the next antenna.
4. Repeat until all antennas have been tuned.
1
2
3
5
7
8
6
4