User Guide

Reader Manager Guide Page 39 of 62 40-10-006-DOC 15/09/2006
No configuration is written to the reader until this point.
If you click Save Configuration to save the configuration as a file on the hard disk, you must also
click Save to Reader to write the configuration to the reader.
If you do not click Save to Reader the reader will remain in an un-configured state.
This form is shown in Figure 28 and the elements are described in Table 15.
Figure 27
Index Description
1 Setup progress – should show Setup axis as being complete.
2 Form instructions.
3 Click this to write the configuration to the reader.
4 Click this to save the configuration to a file which is saved on the hard disk.
5 Click this to go back to the Setup axis form.
6 Click this to go to the Setup tuning form.
Figure 28
The typical usage of this form is as follows:
1. Click Save to Reader.
2.
Click Yes when asked to save to the reader.
3. Acknowledge the configuration has been saved when the message box is shown.
1
2
3
4
5
6