ASSEMBLY INSTRUCTIONS SUN LOUNGER NOTE: 50% TIGHTEN BEFORE FIXING ALL BOLTS
D H K J G I B C E A F Notice: 1. 50% Tighten before fixing all screws, Allen wrench is recommended instead of an electric drill. 2. Place the item on a flat ground to adjust and make sure it remains stable 3. Tighten up all screws with tools gradually. 4. If the screws are not aligned with holes during assembly, please loosen all the other screws to 50% and continue the assembly process. 5.
Part List A B Right Frame (1pc) D C Left Frame (1pc) E Side Left Frame (1pc) G F Front Frame (1pc) H Seat Frame (1pc) I Right Arm (1pc) Back Frame (1pc) Back side Frame (1pc) J Side Right Frame (1pc) K Left Arm (1pc) Seat Cushion (1pc) Hardware List 1 2 Bolt M6 x 20 mm 2 pcs + extra 1 pc 4 3 Bolt M6 x 30 mm 12 pcs + extra 2 pcs 5 Bolt M6 x 55 mm 2 pcs + extra 1 pc Bolt M6 x 40 mm 8 pcs + extra 1 pc 6 M6x1 Washers 24 pcs + extra 2 pcs 3 Allen key M4 (2 pcs)
STEP 1 STEP 2 Connect Left Frame (B) & Side Left Frame (D) with Bolt (2) & Washers (5) Connect Right Frame (A) & Side Right Frame (C) with Bolt (2) & Washers (5) 2 2 C D B A STEP 3 Connect part from STEP 1 & Front Frame (E) & Back side Frame (G) with Bolt (2) & Washers (5) 2 G 2 E 4
STEP 4 Connect part from STEP 2 & STEP 3 with Bolt (2) & Washers (5) 2 2 STEP 5 Connect part from STEP 4 & Seat Frame (F) with Bolt (2), (3) & Washers (5) F 3 3 3 3 3 2 2 3 5
STEP 6 Connect part from STEP 5 & Back Frame (H) with Bolt (1) & Washers (5) 1 H 1 STEP 7 Connect part from STEP 6 & Left Arm (J) with Bolt (2), (3), (4) & Washers (5) J 4 3 2 6
STEP 8 Connect part from STEP 7 & Right Arm (I) with Bolt (2), (3), (4) & Washers (5) 4 3 2 I STEP 9 Backrest tilt angle can be adjusted 7
STEP 10 Put on Seat Cushion (K) to Complete sun lounger K STEP 11 FINISH 8
