Instructions / Assembly

Cup holder
Plank
32
1 pcs
1 pcs
8 pcs
2 pcs
2 pcs
4 pcs
2 pcs
2 pcs
1 pcs
1 pcs
1 pcs
I
J
AA
BB
CC
DD
EE
FF
GG
a
b
PRODUCT COMPONENTS
5. First, screw bolt DD into Part E as shown
in the picture, then insert the washer from
the end of bolt, and finally screw part E into
the hole position as shown in the picture
and fix it with nuts.
6. First, screw the bolt DD into the part
F as shown in the picture, and then
insert the washer from the end of the
bolt.Then insert the bolt DD into the
armrest D as shown in the picture and
fix it at the end of the bolt with nuts.
3. First insert the bolt CC into the part F as
shown in the picture, then insert the washer
from the end of the bolt, and finally screw it
into the hole position shown in the picture for
fixation.
4. Screw the bolt AA into part g and fix it
on part F as shown in the picture.
D
C
DD
DD
CC
CC
F
AA
AA
G
DD
DD
E
E
4*40 Screw
M6*50 Bolt
M6*50 Bolt
M6*50 Bolt
For tightening bolts
For tightening nuts
M6*50 Bolt
M6*80 Bolt
M6*40 Bolt
Operations
1. Thread bolt BB into part J as
shown in the picture, and tighten
it with screwdriver a.
J
BB
BB
AA
AA
H
2. Lay part H flat as shown in the
picture and screw bolt AA into
part H with screwdriver a.