Operation Manual

Manual Indicator SA 250
pag. 7
PCG/C SA 250 Indicator Manual 23-03-07
Four functions of the procedure of data transmission may be selected
in the User Menu:
0. Switched off
1. 1 x printing (or transmission to a PC) after pressing key
Transmission is executed if:
- the reading has standstill at pressing the key ( symbol is on)
- the reading has had a standstill at 0, after the last transmission
- the reading is > 0
After pressing key a short “beep” sounds to confirm the transmission.
A longer “beep” indicates that no transmission will be executed, since there is
no standstill of the weight value, or the reading has not been stable at zero
before (not active in the Hi-Lo mode).
2. automatic 1 x printing (or transmission) after each weighing
Transmission is executed if:
- the reading has come to a standstill ( symbol is on)
- the reading has had a standstill at 0, after the last transmission
- the reading is > 0
- the reading is in the weighing mode
3. continuous transmission
Print of weight:
In the weighing mode only. Transmission speed is about 10 Hz.
Attention: gross negative values are transmitted too.
At loads above the maximum scale capacity the transmission stops.
In this mode the selected extra empty printing lines, before and after the actual
data, are not transmitted.
Printing examples
Print of counting / weighing (HR version): G = gross
N = net
T = tare
QTY … PCS = quantity … pieces
PCW = piece weight in grams
The empty spaces above and below the printed lines may be selected
(max. 9 empty lines) in the User Mode.
WEEGTECHNIEK HOLLAND B.V. Website www.weegtechniek.nl Tel [phone]
Patroonsweg 23-27 Email info@ weegtechniek.nl Fax [phone]
3892 DA ZEEWOLDE The Netherlands
Printing / sending data
NET
30.240 kg
28.750 kg
7.890 kg
G 20.196 kg
N 20.196 kg
T 0.000 kg
QTY 403 PCS
PCW 50.0699 g
G 5.041 kg
N 4.344 kg
T 0.697 kg
QTY 856 PCS
PCW 5.07199 g