Operation Manual

Manual Indicator SA 250
pag. 5
PCG/C SA 250 Indicator Manual 23-03-07
Add the article with the correct weight on the platform and press key .
The reading sets zero. The symbol  at :
NET shows up.
Replace the article for the item to be checked and read the deviation in + or -.
This tare may be deleted by pressing key with an empty platform.
1. Count by hand a number of articles: 10, 20, 50,100 of 200 pieces.
The less weight of an article, the more pieces have to be used in order to
achieve an accurate counting.
2. Take care of an accurate zero reading: and standstill: .
Add the pre counted articles in one operation upon the platform.
3. Press keys . The available quantities show up on the display
as running numbers. Press key again at the moment the correct
quantity appears on the display.
4. Now the scale counts the number of articles, the display shows the number
of articles.
The arrow at indicates that the parts counting mode is in operation.
5. With key may be switched (i.e.) from the counting mode to the
weighing mode, and back. The weight of the article is not deleted by this.
If an other article has to be counted, go back to the weighing mode with key
and start at point 1. again.
Note : in this program negative counting (after taring) is not possible
The Hi-Lo function offers the feature to do a very quick check on the weight of
series of articles, or to fill constant quantities, within the settable weight ranges.
Two weight values may be entered. These values will be used as upper and
lower limits, indicating that a measured weight value is:
- HI = weight too high
- OK = correct weight
- LO = weight too low
The three LED’s left next to the display indicate the weighing result in red,
green or yellow. Long or short “beep” sounds may be connected to the HI, OK
and LO functions via the User Mode (page 11).
Setting of the weight values is done with key , see next page
On the condition that weight values have been entered, pressing key
starts and stops the HI-LO function, as well as the counting function.
WEEGTECHNIEK HOLLAND B.V. Website www.weegtechniek.nl Tel [phone]
Patroonsweg 23-27 Email info@ weegtechniek.nl Fax [phone]
3892 DA ZEEWOLDE The Netherlands
Check weighing (in weighing mode only)
Hi-Lo check weighing (in weighing mode only, if selected in the USER mode)
Counting parts
NET
NET
NET
NET